Pse-archery X Factor Manuel d'utilisateur télécharger pdf (Page 4)

STRINGING

Special attention must be given to the proper procedure for stringing your X Factor

bow. The safest and the only procedure recommended by PSE is to use PSE Bow

Stringer P/N 41076, which is available from your local PSE dealer.

When using a PSE Bow Stringer use the following procedures:

Twist the bowstring to the desired length. Place the larger loop of the bowstring over

the upper limb and slide it down the limb a few inches. Place the smaller loop of the

bowstring into the string groove on the lower limb. Next, place the large cup of the

bow stringer over the tip of the lower limb and the small cup over the tip of the uppe

limb. With the upper limb to the left, step on the middle of the bow stringer and pull

up on the bow riser grip with the right hand. With the bow flexed sufficiently, slip the

upper end of the bowstring into the string groove of the upper limb. Slowly lower the

bow and remove the bow stringer.

To unstring the bow, reverse this procedure.

NOTE: If a PSE Bow Stringer is not used, carefully follow the instructions that

come with the bow stringer.

-4-

1 2 3 4 5 6 7 8

Pas de commentaire

Pse-archery X Factor Manuel d'utilisateur Page 4